Bộ Kit Gắn StealthBurner CW2 Cho Elegoo Neptune 3 Pro/Plus/Max

A total re-design of my bowden version which was a remix this model was designed from scratch using the same dimensions but cutting out more material for clearance. I've also added a heatset hole in the side for the original neptune inductive probe.

Probe location is 2(ish)mm higher than where the nozzle should land.

Update, Version 8:
Dropped the whole thing 8mm as V7 wouldn't reach the bed if hard mounted, also fixed probe location to prevent interference with the backing plate.

Update, Version 9:
This is the final iteration used on my machine, it spaces the printhead far enough forward to allow the use of pan/cap head screws to fit to the original carriage and also moves the probe forward 2mm.

Printing:
Printed in PLA for Prototyping, ABS Reccomended.
.2 Layer Height
No Supports Needed
40% Infill
4 Walls,
4 Top & Bottom Layers

Parts Needed:
Stealth Burner Toolhead + Screws for fitting.
7x M3 Heatset Inserts
3x M3x18mm Screws
3x M3 Nuts (Nyloc reccomended)
1x M3x10mm Screw (Probe)

Klipper Config:
Probe Offsets:
x_offset: -29.3
y_offset: 32.37