Skip to main content
F3D
Corner Clamp – Kẹp Góc In 3D Không Cần Supports 1

2 images

DIY

Corner Clamp – Kẹp Góc In 3D Không Cần Supports

By PirateSands2_1386703

Downloads
4,821
Likes
1,587
Views
16,208

Files 13 28.6 MB

  • Small_Corner_Clamp_Base_1777463832.stlSTL · 442.3 KB
  • Small_Corner_Clamp_Screw_Block_1777463833.stlSTL · 92.2 KB
  • Small_Corner_Clamp_Screw_1777463833.STLSTL · 1.6 MB
  • Small_Corner_Clamp_Screw_Loose_1777463835.stlSTL · 1.6 MB

Make a variant with AI

Build another version of this model.

Open Studio

Description

Motivation

I wanted a clamp that didn't need me to purchase a separate threaded bar, was strong enough to use for woodworking projects and significantly cheaper than metal clamps. I prefer this single screw design for being quick to adjust, and I just use packers if working with two different thicknesses of material.

Printing

Use the Small variant for materials up to 1 inch / 26mm and the Large for sizes up to 1.75 inch / 45mm.

Print with the base and screw block flat on the base, with the screw vertical. Doing it this way no supports are needed, and the threads will print fine. Most of the strength comes from the perimeters so I would use at least 3, and 20% infill is perfectly sufficient.

Mine are printed in PLA, which works fine but they do suffer from creep deformation if clamped for a while. I therefore recommend using PETG or ASA, or even better Nylon if you have access to it.

Usage

Before first use I recommend winding the thread all the way in and out once to clean up the threads. They should be tight but not binding, you may want to use an exclusive slicing tolerance if you have an issue here, but mine didn't require it. Adding a dab of silicone grease will make the whole assembly a bit smoother.

Being plastic there is a limit to the clamp's strength, with the primary failure mechanism being flexing of the baseplate. Consequently just stop tightening when you see the baseplate begin to flex visibly, and this way you won't snap the screw.

Updates

24/02/2024: Version 2 adds a captive screw block, better threads and a larger size variant.

10/03/2024: Version 2.1 strengthens the screw housing and provides optional new screws with looser tolerances.

Any issues or features you would like, just leave a comment :)

Read more Show less

Print spec

Formats
gcodestl
Model files
13
Total size
28.6 MB
Largest file
10.2 MB

0 comments

See all