Vỏ Voron Camer Module Housing

The angry cam design is very nice. The camera can be on the gantry or frame. But I don't like the requirement for removing the cable connector to get through the side mounting blocks. To me the side mounting block could just be wide open. So I made that. 

The design clamps the camera board in between two body halves. I did reserve the screw holds at where the camera module have mounting holes to allow a M2-self-tapper to be used to pull things together. The two halves should stay together without the screw, there are overlaps between them that naturally holds them together, and the side mounts also help.

The back half have a big cutout basically the same width as the camera module to allow for heat-sinks. (The Arducam IMX219 I got have a huge heatsink, it will fit).

Mounting the module to the gantry using the side piece. It is also wide open for routing the cable in any direction. The side pieces also help holds the two halves together. I made two different versioned side piece. One is cut open, other one is a full circle. Idea being some might want to put the housing in without connecting the wire through” the side mounts. 

The model I made is for a different camera module (Arducam IMX219 in particular) , so doesn't have the LED cutout, and likely have some small details might not be compatable to all camera modules.

The model requires a tiny amount of support to print on the rear-body piece. Setting “support on built plate only” is enough 

I made the design with on-shape, it's available for anyone to made copies and modifications: on-shape

The crack/warp look in the photo is due to my ABS print get warped, the model should assemble clean without gap.