Chụp che cáp USB cho Adventurer 4

About the design

The Flashforge Adventurer 4 series has a convenient USB-A port on the front of the machine, used to upload models into the printer memory.  USB ports generally become worn over time, so it was an idea to install a short USB-A(m-f) cable extension on the front of the printer. I used a 90-degree cable for this purpose. This prevents wear on the machine' front port.

The cover plate secures the USB-A(m-f) extension cable on the front corner of the Adventurer 4 series printer where it is out of the way when you are working inside the printer or changing filament.

Parts

• USB extension

https://www.amazon.ca/GOOOA-USB-Extension-Data-Cable/dp/B07LGC2Y7Q/ref=sr_1_5?keywords=90%2Bdegree%2BUSB%2Bcable&sr=8-5&th=1

Printing Instructions

Printed with 

• 0.4mm nozzle
• 4 walls
• 0.22 layer height
• PLA or choice of material

Print the plate standing up, with the cable clips closest to the print bed.  

Supports are required from the bed to the underside of each cable clip. 

Additional Notes

 The plate is adhered to the front of the printer using small squares of double sided tape.