Skip to main content
F3D
Block chà nhám 125x20mm tối ưu hóa bề mặt 1

1 image

DIY

Block chà nhám 125x20mm tối ưu hóa bề mặt

By dchit1_3960899

Downloads
9
Likes
1
Views
40

Files 5 928.2 KB

  • sanding_block_1784618743.3mf3MF · 156.9 KB
  • lock_1_1784618744.3mf3MF · 7.1 KB
  • lock_2_1784618745.3mf3MF · 7.2 KB
  • knurled_nut_1784618746.3mf3MF · 451.3 KB

Make a variant with AI

Build another version of this model.

Open Studio

Details

Model ID
#414467
Category
DIY
Published

Description

There's no shortage of sanding blocks on pintables, but the goal was to use most of a 20mm strip cut from 125mm wide sandpaper roll on the one surface. I probably could've gone further to save another 6mm, but here we are.

Print as oriented, block needs supports for the two threaded posts, may as well chuck a strip in for the grip section while you're there. I printed pretty standard 0.2mm 15%, 4 walls. Seems stiff enough in PETG.

Printed the nuts at 0.12mm hoping something great would happen.

The not-really-knurled-but-that's-what-I-named-them nuts were tight enough I ended up using pliers to tighten, so the hex ones and a knipex pliers wrench is a better option (use of other tools unacceptable). Also the "knurled" ones I uploaded in the wrong orientation and that makes me a bad person but I didn't save the model with that pattern. You can probably figure out which way they print best (as could your slicer. but I still feel bad)

The choice of sandpaper camouflaged on a grey print was unintentional.

Read more Show less

Print spec

Formats
3mf
Model files
5
Total size
928.2 KB
Largest file
451.3 KB

0 comments

See all