Bộ Nối Dài Spool Holder (Spool Holder Extender)

I printed the design this remix is based on, and it held for a little while before the layers peeled apart and the whole thing broke. I liked the ridged design but needed something sturdier, so I combined it with the second design this remix is based on, and so far I have had no issues with it.

Installation

Apply some superglue to the nubs, then push them into the main piece. Friction fit existing holder into the open side. It will be tight but just push with a little bit of force. Now you are ready to twist it on just like you would the original holder.

Print Settings

Print without supports and a brim if desired. I recommend at least 3 perimeters and 40% infill or higher for the main piece. For the nubs, those should be fully infilled with 4-5 perimeters for more structural stability.

Other

If you found this model useful, please give it a like, as it really helps me out.

Thingiverse Link: coming soon!