Bộ adapter đệm thùng Ikea Samla cho Snapmaker U1

The Ikea Samla most recommended as a Snapmaker U1 cover is not tall enough on it's own to work without interfering with the printer's Bowden tubes. Some additional height is needed.

I just needed thermal and draft stability for PLA, so didn't need the fully sealed enclosure plans others have made. To avoid hours of printing and much more filament use, I designed these simple props instead. They fit in the Snapmaker U1 hood mounting points, and you just place the Ikea Samla tub over them.

Gravity and a bit of a U-shape has been plenty to hold this together through months of printing.

SUPPORTING YOUR FAVORITE DESIGNERS:

If you want to help inspire me to post more stuff, please consider using the affiliate link below to get to Amazon the next time you are inclined to go there.

PLA+: https://amzn.to/4wZ4J8J  

INSTRUCTIONS:

• Print 2

• They are sort of directional. Place both opposite each other so they are in the mounting point at the back (or front I suppose).

• Put the tub on. Be careful of the Bowden tubes. The Samla can catch on them.