Mô hình HAL 9000 trang trí máy in

Extra parts needed: 4 – 8 magnets depending on how you wish to attach it. (Main body needs 2 magnets, side holder needs minimum of 4 magnets, hal magnet holder door needs 2 magnets); Super Glue to attach parts together.

The holes in the model are made for some 12mm x 4mm I hade laying around. (I have included files in the folder “for magnet text modification STL files” so you can easily modify the models in Prusa slicer for the magnets you might have hanging around.

Print settings

All files have a 0.15mm clearance and were printed with 0.2mm heights, 15% infill, and no support unless noted below.  The ironing was done for esthetics and isn’t needed. 

“Side holder”: Supports for magnet holes facing print bed.  Printed with the “L” and “R” letters facing down. The “L” and “R” indicate which side of the door you want to place it. Place magnets only into the holes that are next to the letter you are planning to use.

“Hal magnet holder door”: pause at  4mm to insert magnets (with the thin lower layer facinf down.

“Hal main body”:  In the image I changed the layer height to 0.1mm from 4.0mm to 6.4mm (top)

“Hal screen”: In the image I changed the layer height to 0.1mm from 0.4 mm to 1.6mm (top) Colour changed from black to silver at 0.6mm.  Ironing enabled on silver top surfaces.

“Hal black inset”: ironing enabled for top surfaces

“Hal core inset”, “Hal HAL inset”: 0.1mm print layers,  colour change at 1.7mm

“Hal 9000 inset”: 0.1mm print layers,   colour change  at 1.3mm,   Iron enabled for all top surfaces

“Hal lens”:  0.1mm print layers (image shows sanding post processing)

Filaments used in images (all are polymakers Panachroma PLA):

Matte Sapphire Blue: for hal hal inset and hal core inset

Starlight Mars: for hal lens

Silk Silver: for hal main body

Matte Charcoal Black: for hal screen, hal 9000 inset and hal black inset

Steel Gray: for screen

Neon Orange: for core inset

Cotton White; For 9000 inset and hal inset

Extra files:

“hal 9000 inset blank”, “hal inset core blank”: have been include so your own text can be added in Prusa slicer

“hal side holder micro”, “hal magnet door micro”, “hal main body micro mag”, and “hal magnet door micro magnet”: have 4mm diameter x 1mm depth holes where the magnets go so you can use Prusa slicer to added negative volume to fit the magnets you have

(if you plan to attach on the door make sure your magnets are completely covered to protect the door from possible scratching!!!!!)

“hal 9000 f3d file” and “hal 9000 step file”: added so you can easily modify the model