Nắp đậy chống bụi cho Elegoo Centauri Carbon 2 (TPU)

I made some TPU covers for the holes located at the bottom of the CC and CC2 printers, since they tend to fill up with debris from failed prints.

WARNING: Remove the covers when printing tall models. These covers reduce your maximum print height.

The covers are printed in TPU so they can be installed as a single piece by wrapping them around the smooth rod. You will need three if you want to cover all the holes, but honestly the two in the front collect the most debris, so the rear one might not be as necessary.

They are designed to be a tight fit, but still easy enough to remove. I did not have any issues taking them off.

I also have an idea for a dust protection solution that would not need to be removed. I think it could work, so if there is interest I might experiment with it and upload a different version later.

Hope someone else finds this useful :)