Elegoo Centauri Carbon 2 waste chute

Update 14.08.2026: Added a V2 Version of the drawer, hopefully it's gonna make it easier to empty the drawer.

Overview

The first thing I made after receiving my CC2.

This is a simple side drawer where the “handle” is just a hole. It works both as a grip and as a quick way to see inside without pulling the drawer out. That way you can easily check if it is getting full.

I originally designed it with a normal handle, but realized this solution gives more functionality with less bulk.

Design Details

There are 4 slots for 10x3 mm magnets, but you will probably be fine with just one or even none.

My printer sits on a table that shakes quite a bit when running fast, so I added the magnet option to prevent the drawer from slowly sliding out.

The uploaded version has a few small tweaks. I slightly loosened the tolerances since my original print was a bit snug. It is still designed to fit tightly. And some other light tweaks.

What You Need

2x 15 mm M3 screws for the top
1 to 4 10x3 mm magnets optional
Bottom screws are the original M3 screws

Compatibility

There is a chance you can flip this and use it on the original Centauri Carbon as well, but I have not tested it.

Future Updates

I might rework it, slim it down, and make some improvements later if there is demand for it.

Please let me know if there is anything you would like to see in a future model