
Nắp pin thay thế cho Mitutoyo Micrometer (Replacement Battery Cover)
Remix of Nắp Pin Thay Thế Cho Mitutoyo Micrometer (Mitutoyo Micrometer Battery Cover) By GreatOldOne
- Downloads
- 134
- Likes
- 7
- Views
- 712
- Remixes
- 0
- Comments
- 0
Files 4 736.9 KB
- Tantalus_Mitutoyo_Battery_Cover_-_Body_Insert_1776968307.3mf3MF · 42 KB
- Tantalus_Mitutoyo_Battery_Cover_-_Main_Body_1776968308.3mf3MF · 119 KB
- Tantalus_Mitutoyo_Battery_Cover_0.15mm_PLA_MK2.5S_8m_1776968309.gcodeGCODE · 360.2 KB
- Tantalus_Mitutoyo_Battery_Cover_Drawing_1776968311.pdfPDF · 215.8 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #331547
- Category
- DIY
- Published
Description
This is a remixed project of the Mitutoyo Micrometer Battery Cover by GreatOldOne.
After printing the original design by GreatOldOne, to replace a broken Battery Cover for our 1-2” Mitutoyo Mic. I noticed that the fit was not as I expected as it was recessed and didn’t sit flush with the body of the mic.
About the Design:
I completely remodelled the part in Fusion 360, taking direct measurements from the original broken battery cover I have also included a dimensional drawing reference. I made a few improvements first; I cleaned up the start Thread (Fig.1) I also reduced the interference fit between the body and insert.
If you have any questions, please feel free to contact & if you print it, please share your make and let me know the model of your micrometer.
Compatibility List:
Series 227 - Should be compatible but not confirmed.
Series 293 - Confirmed.
Series 314 - Should be compatible but not confirmed.
Series 317 - Should be compatible but not confirmed.
Series 323 - Should be compatible but not confirmed.
Series 326 - Should be compatible but not confirmed.
Series 329 - Should be compatible but not confirmed.
Series 340 - Should be compatible but not confirmed.
Series 343 - Should be compatible but not confirmed.
Series 350 - Should be compatible but not confirmed.
Series 369 - Should be compatible but not confirmed.
Series 395 - Should be compatible but not confirmed.
Series 406 - Should be compatible but not confirmed.
Series 422 - Should be compatible but not confirmed.
Printing requirement:
Layer Height 0.15mm.
Perimeters 2.
Top & Bottom Layers 4.
Infill can be set to 0% or left unchanged.
Supports Required No.
Filament:
I used Prusament PLA Jet Black worked fine I am confident that it could be printed in other Materials.
Post Production:
Remove support press-fit together if loose a small amount of glue can be used.
Print spec
- Formats
- 3mfgcodepdf
- Model files
- 4
- Total size
- 736.9 KB
- Largest file
- 360.2 KB
0 comments
You may also like 12 models
See all-
New -

-

-

-
New -
New -
New -

-

-

-
New -


