Ngàm gắn USB Camera 3DO v2 chỉnh được (Adjustable 3DO v2 USB Camera Mount)

I printed with standard voron settings. 4 walls, 5 top/bottom layers and 40% infill and 0.2 layer height. Probably more than needed.

Parts should already be orientated for printing. 

enclosure-cam-baseplate.stl - print this with supports from the build plate. I use a spacing (top and sides) of 0.4 and when I pop the part off the plate the support usually stays on the plate

You only need one of these:
enclosure-cam-mount.stl - uses 5x4 heatsets
enclosure-cam-mount-m3-nut.stl - uses M3 nuts

Hardware needed:
2 - M3x8 to secure the baseplate to the mount
2 - M3 washer (optional) between the M3x8 bolt and mount
2 - M3 nuts (or 2 5x4 heatsets)
2 - M2x8 (10 should also work) to secure the cover to the baseplate
Optional - M2x6 (8 should also work) to secure the board to the cover

If you use the M2x6 self tapping screws to secure the board to the cover, be extremely sure that you do not over tighten and that the head is small enough that it doesn't short anything.

This is totally optional. The board should pinch between the 2 parts. I never got it to hold the way I wanted, either too loose or too tight so I opted for screws.

Note: The design centers the camera lens hole according to 3DO's step file. For me, I had to move it around to get it where I wanted. Adjust it in the step if it is off too much for you.