Skip to main content
F3D
Vòng đệm cho Hygrometer RepBox 1

3 images

Máy In 3D

Vòng đệm cho Hygrometer RepBox

By Bouggo_176606

Downloads
94
Likes
16
Views
551
Remixes
1
Comments
6

Files 2 506 KB

  • HyAussen_0.2mm_PLA_MK3SMMU2S_12m_1766157941.gcodeGCODE · 446.2 KB
  • HyAussen_1766157940.stlSTL · 59.8 KB

Make a variant with AI

Build another version of this model.

Open Studio

Remix versions 1

See all 1 remix

Description

English below

Bei den RepBox-Kästen schlackert das Hygrometer locker an der Frontwand herum. Da gibt es die Empfehlung, alle Ecken und Kanten mit Silikon abzudichten und hier kann der Wasserdampf nach Belieben einströmen.

Ich wollte das Problem mit einem zusätzlichen Ring lösen, den man in den Spalt einklemmen kann. Konstruierte zuerst einen für innen. Das haut allerdings nicht hin, weil sich dann die Befestigung am Gerät nicht mehr ausreichend eindrücken lässt. Also das Gleiche nochmals für außen gebaut. Das klappt gut. Sieht zudem recht gut aus.

With the RepBox boxes, the hygrometer loosely flaps around on the front wall. There is the recommendation to seal all corners and edges with silicone and here the water vapor can flow in at will.

I wanted to solve the problem with an additional ring that can be clamped in the gap. Constructed first one for inside. However, this does not work, because then the attachment to the device can no longer be sufficiently pressed in. So I built the same again for the outside. That works well. It also looks quite good.

Read more Show less

Print spec

Formats
gcodestl
Model files
2
Total size
506 KB
Largest file
446.2 KB

6 comments

See all