
Miếng đệm cao su TPU cho kẹp gỗ
- Downloads
- 162
- Likes
- 72
- Views
- 638
- Remixes
- 0
- Comments
- 0
Files 2 76.1 KB
- wood_clamp_rubber_grooves_1775195723.3mf3MF · 43.2 KB
- wood_clamp_rubber_no_grooves_1775195724.3mf3MF · 32.9 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #284203
- Category
- DIY
- Published
Description
A while ago I purchased online some cheap woodworking clamps. One of them has snapped & I lost that bit, found model already to print, but I also lost rubber anti slip pad, so I have designed same one to print from TPU.
I have used TPU 95A to print them, seems to be good enough to hold it in place. It's not too loose-not too tight fit, same as original ones, but I'm adding a drop of CA glue anyway just to hold it in place as it tends to slide out while clamping, at least in my case all original orange ones were doing it.
I made two version - with and without grooves, it's up to you.
Model prints best in 0.16mm layer, slowly with just generic Bambu TPU profile and some random TPU filament that I had handy, only tiny bit of support needed around top edge, it's easy to pull it out with traditional supports, so those are added into 3mf files.
I thought I'll share this model as someone might be missing them as well :)
Remixes and sharing allowed, as long as you keep original link&credits.
Print spec
- Formats
- 3mf
- Model files
- 2
- Total size
- 76.1 KB
- Largest file
- 43.2 KB
0 comments
You may also like 12 models
See all-
New -
New -
New -

-
New -

-

-

-
New -
New -
New -
New

