
DIY
Vỏ bảo vệ cho Waveshare ESP32-S3-ETH kèm camera OV2640 và module POE
- Downloads
- 254
- Likes
- 13
- Views
- 1,314
- Remixes
- 0
- Comments
- 0
Files 8 752.6 KB
- Waveshare_ESP32_LAN_ETH_Cam_POE_case1-BodyUSBPlugLEDBlank.stepSTEP · 22.9 KB
- Waveshare_ESP32_LAN_ETH_Cam_POE_case1-BodyCaseBottom.stepSTEP · 147.3 KB
- Waveshare_ESP32_LAN_ETH_Cam_POE_case1-BodyCaseTop.stepSTEP · 132.6 KB
- Waveshare_ESP32_LAN_ETH_Cam_POE_case1-PrusaSlicer.3mf3MF · 81.6 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #256262
- Category
- DIY
- Published
Description
This is an enclosure for this board from Waveshare with POE-module and OV2640-camera which you can get on Ali and other sources.
not fancy or pretty, but functional, lightweight, space-saving and filament-saving ;P
Addons
I also made an adjustable wall-mount for the camera-ESP, which you can find here.
In case the top and bottom part, still don't hold tight enough for you, you could consider printing just the clamp from the mount.
Assembly
- drop board into big bottom part
- close case by clipping-in top lid
- optional: plug in USB-C protector
Features
- slot for camera-cable
- space to mount camera
with double-sided tape - accommodates POE module
- breakout for antenna
- hole for WS2812 LED.
(image on the right) - extra USB-C plug for darker LEDs
- NO GPIO access yet, but there is a remix that exposes some pins.
Printing
- any material
- layer height: ≤ 0.3mm
- nozzle size: ≤ 0.6mm
- no support
- no brim
- infill: 25% aligned rectangular (or something else that enables smooth surfaces)
History
2025-07-13: v1, still somewhat WIP
2025-07-15: v2 improvements:
- better LAN Act-LED shade
- hole for WS2812 LED
- bigger clip and notches for stronger fit of top to bottom part
- USB-C plug for additional shade of LAN Act-LEDs and protection of USB-C plug
Print spec
- Formats
- 3mfobjstep
- Model files
- 8
- Total size
- 752.6 KB
- Largest file
- 174.1 KB
0 comments
You may also like 12 models
See all-

-

-

-

-

-
New -

-

-

-

-

-


