
Raspberry Pi Pico LAN Tester
- Downloads
- 100
- Likes
- 0
- Views
- 0
- Remixes
- 0
- Comments
- 0
Files 4 628.6 KB
- Top.stlSTL · 140.4 KB
- Bottom.stlSTL · 378.6 KB
- Button.stlSTL · 98.9 KB
- Switch.stlSTL · 10.6 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #419236
- Category
- DIY
- Published
- License
- Creative Commons — Public Domain
Description
You can buy the KIT<HERE>

This is the 3D printed enclosure for my portable Raspberry Pi Pico LAN Tester.
The device uses a Raspberry Pi Pico, W5500 Ethernet controller, SSD1306 OLED display, custom PCB, LiPo battery and USB-C charging. The case includes openings for the OLED, push button, RJ45 Ethernet connector, USB-C port and side switch.
The full step-by-step build guide is available on Instructables:
INSTRUCTABLES
## Print Settings
- Material: PLA or PETG
- Layer height: 0.2 mm
- Infill: 15–25 %
- Supports: only if needed
- Hardware: M3 screws and M3 heat-set inserts
## Project Files
The firmware, KiCad files, BOM and PCB files are available on GitHub:
https://github.com/Markuselectronics/Raspberry-Pi-Pico-LAN-Tester
Print spec
- Formats
- stl
- Model files
- 4
- Total size
- 628.6 KB
- Largest file
- 378.6 KB
0 comments
You may also like 12 models
See all-
New -

-
New -

-

-
New -

-

-

-

-

-


