Slim Snap-Fit case for Waveshare ESP32-S3 RLCD 4.2 board

Simple snap-fit case for the Waveshare ESP32-S3 RLCD board. Gives a little better protection to the fragile reflective LCD. Leaves cutouts for the GPIOs, SD card and speaker. Leaves all three buttons accessible. Includes ports for the microphones and temperature sensor. Leaves the battery exposed so it's easier to remove.

Print instructions:

• Print from PLA or PETG using 0.13-0.15 layer height

• case_front 1x, case_back 1x, button 3x

• Print without supports

• You might need to clean the overhangs around the buttons if your bridging isn't dialed in

Assembly:

• Hold the front panel vertically upside-down and place the buttons in the case, make sure the buttons move freely (reprint the buttons at 95% scale in x and y if they're stuck)

• Insert the dev-board

• Snap on the back panel, you can screw in the board using the original screws but the board locates nicely in the indented holes so it's not necessary

• Insert the legs, you can reuse the acrylic legs that the board came with or if they're already snapped, print new ones, the files for it are included