Tiny K-3

Tiny-K3

I designed this because I needed a small printer.

It’s a bit of a Frankenstein build — combining the X/Y gantry from Annex K3, the Z motion from Voron, and the Z-tilt system from RatRig.

The toolhead is a modified version of the TOF design.

I also added X and Y endstop switches, which are not included on the original Annex K3.

The bed size is 150 × 150, with a little extra margin on both sides.

The X and Y gantry layout is the same as the original Annex K3, but each axis is shortened by 10mm.

It hasn’t been built yet — for now, the design phase is complete.