Kẹp ống PTFE (2 ống)

I recently picked up the sunlu s4 4x filament dryer to use as the main dryer and feeder to the CC2, however when i set it all up the tubes were just a horrible mess

So i designed this clip to manage the tubes into somthing a bit more manageable and cleaner looking

The holes are slightly too big so you can slide them easily, i recommend using a small zip tie to secure the clip in place once you have it where you want it

Other than that nothing else is needed, and you now have nice tidy tubes!

Ive found my self stretching the z axis out for bigger clips that dont kink the tubes if you bend them into place