
Mũi khắc spring-loaded cho ER16 collet (remix ER11 sang ER16)
Remix of Mũi khắc lò xo cho collet ER11 By dulouie_13364
- Downloads
- 0
- Likes
- 0
- Views
- 112
- Remixes
- 0
- Comments
- 0
Files 2 3.7 MB
- spring_1769036668.stlSTL · 61.6 KB
- ER16-spring-v2_1769036669.stlSTL · 3.7 MB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #201872
- Category
- DIY
- Published
Description
Description
This is a remix of “Spring loaded engraver bit for ER11 collet” by dulouie, adapted to be clamped in an ER16 collet.
Purpose: PCB solder mask engraving / opening with a spring-loaded mechanism that adds compliance and helps reduce the risk of cutting into copper when Z isn’t perfectly consistent.
What changed in this remix
-
ER11 to ER16 interface conversion for compatibility with ER16 spindles/collets.
-
No functional change besides the collet interface: same spring-loaded concept as the original.
Printing recommendations
-
Material (recommended): PC-ABS (best for heat resistance and clamping strength).
-
Wall/perimeters: 4–6
-
Infill: high (≥30%)
-
Supports required: use Tree supports (recommended) due to the geometry (overhang features).
-
Avoid PLA (softening/creep risk under heat and clamping load).
Hardware / tool
-
Typically used with a 60° V-bit for solder mask engraving (same as the original concept).
-
Spring and hardware follow the original model’s approach.
Safety notes
-
This is a printed part used in a rotating tool: start at low RPM, verify clamping, runout and balance.
-
Eye protection strongly recommended.
Original model credit: dulouie ✅
Print spec
- Formats
- stl
- Model files
- 2
- Total size
- 3.7 MB
- Largest file
- 3.7 MB
0 comments
You may also like 12 models
See all-

-

-

-

-

-
New -

-
New -

-

-

-


