Skip to main content
F3D
Con quay cuộn len có chốt trục quay cứng hơn 1

3 images

DIY

Con quay cuộn len có chốt trục quay cứng hơn

Remix of Giá Đỡ Cuộn Len Xoay (Cho Đan/Móc Len) By mshipman_632314

By michelletomasko

Downloads
210
Likes
25
Views
1,124

Files 4 1.3 MB

  • Yarn_Holder_with_Split_Spindle_Peg_v2_1766949039.f3zF3Z · 311.8 KB
  • SplitSpindlePeg_v4_1766949041.stlSTL · 26.3 KB
  • ReinforcedSpindle_v4_1766949041.stlSTL · 180.5 KB
  • Yarn_Holder_v28_Base_1766949043.stlSTL · 790.8 KB

Make a variant with AI

Build another version of this model.

Open Studio

Details

Model ID
#182026
Category
DIY
Published

Description

I love this yarn spinner design but found that the spindle peg was a weak point - over time it would weaken and snap in half on me at the junction between the spindle and the base.  I think it'll be much stronger if it's printed lengthwise so I split it in half lengthwise and print each half with the flat side on the print bed.  Also, this way no supports are needed.  To assemble, just hold the 2 spindle peg halves together while you press fit as in the original design.

I also print the peg in TPU since I thought that might be less brittle and provide some give.  I think PLA would work and still be stronger than the original, though.

Print Settings:

  • Material:  TPU (I used 98A) or PLA for spindle peg, PLA for base and spindle
  • 0.4 mm nozzle
  • 0.2 mm layer height
  • 15% infill

Same instructions as in the original design:

Required Materials:
608 bearing (preferably one without lubrication)

Assembly:
Press-fit the 608 bearing into the base. Press-fit the spindle peg into the bottom of the spindle. Press-fit the spindle assembly into the inside of the 608 bearing. This was designed to be held together with friction, but if needed you can add some CA glue to loose parts.

Read more Show less

Print spec

Formats
f3zstl
Model files
4
Total size
1.3 MB
Largest file
790.8 KB

0 comments

See all