Giá Đỡ Cuộn Len Xoay (Cho Đan/Móc Len)

I designed a 3D-printed version of a spinning skein holder. The spindle is held captive by a small keyed shaft pressed into a 608 bearing.

Print Settings:
0.4mm nozzle
0.2mm layer height
Supports only on spindle and spindle peg
15-20% infill (50+ on the base if you want it to be satisfyingly heavy and not tip easily!)

Required Materials:
608 bearing (preferably one without lubrication)

Assembly:
Press-fit the 608 bearing into the base. Press-fit the spindle peg into the bottom of the spindle. Press-fit the spindle assembly into the inside of the 608 bearing. This was designed to be held together with friction, but if needed you can add some CA glue to loose parts.