
Giá đỡ M-ATX Tối giản cho Rack 10 inch
Remix of Tủ rack server 10 inch in 3D By McBig
- Downloads
- 138
- Likes
- 22
- Views
- 2,014
- Remixes
- 0
- Comments
- 0
Files 1 162.6 KB
- full matx size.stlSTL · 162.6 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #179654
- Category
- Dụng Cụ Tiện Ích
- Published
Description
Warning!
This is experimental. I designed it for a specific setup where the motherboard doesn’t hold any heavy components and is intended to remain stationary (not mobile).
In my previous rack server design, due to the size limitation of my 3D printer (22cm x 22cm), I had to split the mount into two parts. This time, I try to create a new version that doesn’t require splitting.
I tested it with PLA at 20% infill and rail from https://www.printables.com/model/427461-10-inch-server-rack and it turned out quite sturdy. However, I recommend using stronger material and higher infill for better strength. In the photos, I didn’t use PCB standoffs I strongly suggest adding them to prevent soldering points from pressing against the printed base.
Print spec
- Formats
- stl
- Model files
- 1
- Total size
- 162.6 KB
- Largest file
- 162.6 KB
0 comments
You may also like 12 models
See all-

-

-

-
New -

-

-

-

-

-

-

-
New

