Tai gắn tủ rack (Rack Ear) cho Switch Linksys LGS326

Print Settings:

Material: PETG (VoxelPLA Pro eventually failed after 3 years on my similar model)

Walls: 3mm+

Top/Bottom: 1mm+

Infill: 40%+

I couldn't find a cheap set of rack ears for my linksys switch so I designed my own. The bolt pattern is 20x20mm which didn't match up to the Cisco rack ears I had on hand. The switch takes a total of 8 M4 machine screws. Just make sure you bump up your total wall thickness and you should be good to go.

Update 9-19-25:

After 3 years the ones I printed with Grey VoxelPLA Pro failed for my heavier Cisco 10G switch. Upon inspection, I should have made the walls nearly solid and used PETG from the start. Use PETG and make the walls nearly solid. I always leave a little bit of space in case it overextrudes a little bit it can go inside the model and not force out through the top layer or walls.