
Thiết bị kẹp xoay cho chi tiết tròn
- Downloads
- 730
- Likes
- 324
- Views
- 6,251
- Remixes
- 0
- Comments
- 0
Files 12 17.6 MB
- support_1766321309.stlSTL · 550.6 KB
- jaw_3_1766321310.stlSTL · 494.5 KB
- jaw_2_1766321311.stlSTL · 479.7 KB
- guide_1766321312.stlSTL · 249.7 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #171802
- Category
- DIY
- Published
Description
I made a clamping device for round parts.
Printing instructions:
support - 0,2mm layer hight, printed with one side at the bottom (the base is like an “U”), without support
body - 0,2mm layer hight, printed as shown in preview
spindle - 0,2mm layer hight, the section with the thread 0,1mm layer hight, printed with the thread up
spindle_1 - 0,2mm layer hight, printed vertical, the section with the worm gear 0,1mm layer hight
tension wheel - 0,2mm layer hight, printed as shown in preview
clamping nut, clamping nut_1 and clamping bolt - 0,1mm layer hight
guide - 0,2mm layer hight, printed with the smaller area up
jaw 1, jaw 2 and jaw 3 - 0,2mm layer hight, printed with the side with the number down
You need the parts “guide”, “clamping nut”, “clamping nut_1” and “clamping bolt” 2x, all other parts 1x.
I printed mine in petg, works fine. Put a small amount of grease on the worm gear and the spindles when you assemble the device.
Print spec
- Formats
- stl
- Model files
- 12
- Total size
- 17.6 MB
- Largest file
- 3 MB
0 comments
You may also like 12 models
See all-
New -

-

-

-

-

-

-

-
New -

-

-


