Skip to main content
F3D
Wio L1 Tracker Ăng-ten Giấu 1

11 images

Large file collection Dụng Cụ Tiện Ích

Wio L1 Tracker Ăng-ten Giấu

Remix of Vỏ Hộp Ổ Cắm Wio Tracker L1 Pro Cho Meshtastic By SeeedStudio

By Flo_62932

Downloads
10
Likes
2
Views
113

Files 23 11 MB

  • L1_v2_1766190216.stepSTEP · 1 MB
  • front_v2_1766190217.3mf3MF · 241.9 KB
  • reset_v2_1766190218.3mf3MF · 21.7 KB
  • menu_v2_1766190219.3mf3MF · 94.8 KB

Make a variant with AI

Build another version of this model.

Open Studio

Description

I tried to remodel the original design as closely as possible. in fact the original front plate should still fit. 
It's 1 millimetre deeper and two millimetre taller on the outside. but much bigger on the inside. 

Fits 3000mah battery! (65*35*10) with hopefully some wiggle room still.

Everything is kept relatively speaking in the same place, but the antenna has been tucked away neatly and there is room for a larger battery now.
the back has been rounded at the corners to make it feel nicer in the hand, but it still should stand on the table nicely.

Needs M2 screws, because the holes in the board are this small.
Only fits a 10mm diameter antenna for now. (there is a great whip, like in the photo, or the stubbies work too)

Feedback welcome. If anyone has suggestions for changes, those are welcome too. 
 

Come back for optimised buttons. in the meantime, the original fit. 

Assembly instructions: Order is important.
 * first, pigtail. make sure the opening of the connector is pointing towards you.
 * second the battery. you need to latch it in at the bottom first, then gently press it in at the top. the fit is very snug.
 * third: gps. You need to move the rubber pad as in the picture I added, to keep it from rattling. 
 * buttons and board. should be obvious from here.

Read more Show less

Print spec

Formats
3mfstep
Model files
23
Total size
11 MB
Largest file
1.2 MB

0 comments

See all