Hộp Đựng M5Stack Cardputer ADV và LoRa Cap

A storage case for the Cardputer ADV with the LoRa Cap (with the included stock antenna). External case can be printed using your choice of material-PLA, PETG, ABS, etc. The inserts should ideally be printed in TPU for shock absorption (in case this is dropped), but rigid materials are acceptable as well if you choose to use them. 

Keep in mind, these models have only been tested using a combination of rigid outer (PETG, PETG-CF, and ABS) and flexible (TPU) inner, so If you print the inserts using a rigid material you may need to scale up or down to get the inserts to fit properly.

Assembles using 6 M3x30mm screws. You can use BHCS or SHCS.

Don't forget to share your makes, questions, concerns, and comments below! This is my first model submitted to this platform, so any comments are appreciated. 

**I designed the TPU insert to be snug to the Cardputer and LoRa cap--If you want a looser fit, increase the size of every component 0.5-1% in your slicing software. Keep in mind if you size it up too much you will have issues with the screws not threading properly. If this happens, you can use a small drop of superglue on the interior threads of the screw to keep them in place, but be careful when doing so. Obviously you don't want to glue the latches together :)

The external case was created using this tool: 

https://makerworld.com/en/models/1269092-rugged-storage-box-parametric-and-customizable#profileId-1299669

Powered by MakerWorld-Parametric Model Maker (https://makerworld.com/makerlab/parametricModelMaker)