
Trạm Thời Tiết (Gắn Bàn) - DIY với Raspberry Pi
- Downloads
- 33
- Likes
- 2
- Views
- 321
- Remixes
- 0
- Comments
- 0
Files 2 148.9 KB
- WeatherStationV2.01_1765815563.stlSTL · 56.9 KB
- WeatherStationV2.01_1765815564.stpSTP · 92 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #116480
- Category
- Dụng Cụ Tiện Ích
- Published
Description
I made this model because I just recently started 3D Printing and wanted a simple way to monitor the temperature and humidity in my room.
What you'll need:
• A Raspberry Pi. (I used a Raspberry Pi 4 Model B however any similar single-board computer with GPIO functionality will do.)
• I2C 1602 LCD Display Module. (This is a 16x2 character LCD used to show values recorded from the sensor.)
• DHT 11 Temperature/Humidity Sensor. (This is the sensor used to gather temperature and humidity data.)
• 30AWG Wire-Wrapping Wire and a Wire-Wrapping Tool (This is preferred, however, you could use male/female jumper wires.)
• M2.5 x 10 Screws and Nuts. (I used nylon screws which set into the PLA nicely.)
• Double-Sided Mounting Tape. (Place tape on the flat upper region to mount under a surface)
• A 3D Printer to print Weather Station.
Print spec
- Formats
- stlstp
- Model files
- 2
- Total size
- 148.9 KB
- Largest file
- 92 KB
0 comments
You may also like 12 models
See all-

-
New -

-
New -
New -

-

-

-

-

-

-


