
Giá đỡ cuộn filament Skadis V2 cho máy in 3D
Remix of Giá đỡ cuộn cho bảng ghim Skadis By CalsTechConcepts
- Downloads
- 143
- Likes
- 26
- Views
- 1,134
- Remixes
- 1
- Comments
- 5
Files 5 19.3 MB
- skadis-spool-holder-roller-mount-v2-mmu2-rod-120mm.stlSTL · 6.3 MB
- skadis-spool-holder-roller-mount-v2-standard-100mm.stlSTL · 6.3 MB
- skadis-spool-holder-v2-rod-standard-100mm.stlSTL · 161.8 KB
- skadis-spool-holder-roller-mount-v2-stubby-80mm.stlSTL · 6.3 MB
Make a variant with AI
Build another version of this model.
Remix versions 1
See all 1 remixDetails
- Model ID
- #103
- Category
- Máy In 3D
- Published
- License
- Creative Commons — Public Domain
Description
This is a new version of my old Skadis peg board spool holder. I have renamed this “universal” because it works with any of my other universal slide mounts. Currently there are options for the following mountings which are all available here under the mounting slides folder or at the individually linked remixes:
- Skadis/pegboard (IKEA)
- Honeycomb storage wall
- Wall mount (simple counter sunk holes)
- Extrusion mounted (one with lugs for a standard 3030 slot and one with a flat back and two M5 button head bolt holes)
- Ploga mount (IKEA)
- Bekand mount (IKEA) see remix here by DrSnake74 thank you for your work on the design.
There are now also three sizes of spool holder:
- 120mm rod (this is designed to reuse the MMU2S spool holder rods and will fit spools up to a width of 90mm)
- 100mm rod (this is designed to cover as many spools as possible in the smallest amount of space. The rod is printed and works for spools up to a width of 70mm. This works for every spool I have including the old style Fiberlogy spools and Prusament spools.)
- 80mm rod (This is designed to be as small as possible for when space is a premium. However this does limit the spools that can be used on it. The rod is again printed and works for spools up to a width of 50mm. This works well with spools that have an undercut diameter like the e-sun spools I have.)
All spool holders use two 608 bearings and are designed to have a tight snap in fit for the bearings. The old design had the bearings loose in a slot and I was forever knocking them out when moving the holders around. There are now two holes at the bottom of the holder to allow a tool to be used to push the bearings out for disassembly. Once assembled the spool holder rod is now fully retained which eliminates the annoyance of the rod poking out and stopping you from sliding it onto the mounting slide. I have also tried to beef up where I can to make them more rigid and I've removed some of the easy to break geometry too.
I hope this is of use and those swapping from the old to the new design see the benefits. I'm hoping to work on more and improved mounting slides to accompany this project in the near future so any personal suggestion will be greatly appreciated.
Update 13/08/2023: Added link to Bekant mount by DrSnake74.
Print spec
- Formats
- stl
- Model files
- 5
- Total size
- 19.3 MB
- Largest file
- 6.3 MB
5 comments
You may also like 12 models
See all-

-

-
New -

-

-

-

-

-

-

-

-



