Chân đỡ Voron (Voron Rollback Stands)

Disclaimer:   If your printer isn't calibrated correctly, don't blame the design when the integral supports stick too tight.  Use the version without integral supports and generate your own.  You won't have as nice a surface finish on the down facing faces,  but at least it will work.    

A helpful hint.  Go through this guide from the beginning to the end, following every single step: https://ellis3dp.com/Print-Tuning-Guide/

This version is one piece, with thicker compression and tension caps to improve rigidity. I changed the shear web area to more closely resemble Voron's standard honeycomb pattern and added a built-in support.   You will need to remove and toss the print-in-place support.

With these installed, you can roll your Voron onto its back and access the electronics bay underneath.  These will replace the rear lower corner and midspan panel clips.

Edit 4/18/23:  Rotated the honeycomb pattern to match the Voron pattern better.