
Dụng Cụ Chà Nhám Khe Nứt
- Downloads
- 107
- Likes
- 57
- Views
- 661
- Remixes
- 0
- Comments
- 0
Files 2 533.7 KB
- 3.6_x_20_x_75mm_crack_sander_inner_1765750072.stlSTL · 172.9 KB
- 3.6_x_20_x_75mm_crack_sander_outer_1765750073.stlSTL · 360.7 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #101096
- Category
- DIY
- Published
- License
- Creative Commons — Attribution
Description
I needed to sand my outdoor table and it has slats that are 4-6mm apart. I'm sure there's a similar solution to this elsewhere but I didn't really look… This is the design I came up with to quickly and easily get sand paper into those tight cracks while giving me a decent handle to hold. It works amazingly.
The inner piece has ridges along it to stop the paper slipping. The outer piece is under sized so it's a compression fit - no screws or clips to break.
Cut sandpaper to about 80-120mm wide (for the 3.6 x 20 versions) and to the length of the block. Fold it around the inner piece - try to get it fairly tight around the end for a better fit but not critical. Spread the outer (I use my thumb) and fit it around the end of the inner/sand paper combo by about 5-10mm. Place the inner/sandpaper vertically on a flat surface with the outer around the top and press the outer down while holding the paper in place. I find the flat surface helps keep the sandpaper straight.
Sizing:
I made this to suit my specific needs - 4-6mm gap with about 15-20mm depth. If there's demand, I'll make some different sizes available.
Printing:
Print vertically. I'd highly reccommend ASA/ABS (possibly PETG) for extra strength.
I printed using ASA with 0.2mm layers and 6 walls (the default ASA strength profile in Bambu Slicer).
Print spec
- Formats
- stl
- Model files
- 2
- Total size
- 533.7 KB
- Largest file
- 360.7 KB
0 comments
You may also like 12 models
See all-

-
New -

-

-

-
New -
New -
New -

-

-
New -

