FlashForge Finder Simple Filament Reel Holder V1.1

So, for the most part, this is a complete ripoff of the excellent job done by TimmyTopHat, his design in the remixes. Unfortunately, the arm kept falling off for me and I couldn't get the filament tube to sit quite right. So, I did some tinkering and developed a mostly-the-same-but-slightly-different version that has the arm mostly holding onto the body of the printer with a tapered hole to hold the feeder tube in place. Then, to keep that stable, there's a spacer-arm that will hold it neatly in place. The entire thing fits (barely) onto a single build platform and prints in about 2.5 hours at FlashPrint's low quality

Print Settings

Printer Brand:

FlashForge

Printer:

Finder

**Rafts:**

No

Supports:

Yes

**Resolution:**

Low

Infill:

15%

Category: 3D Printer Accessories