Skip to main content
F3D
Máy đo độ căng dây đai GT2 6mm và 9mm 1

1 image

Máy In 3D

Máy đo độ căng dây đai GT2 6mm và 9mm

By Ken226

Downloads
484
Likes
79
Views
4,061

Files 5 11 MB

  • LeftHandedBody_1765750313.stlSTL · 3.5 MB
  • LeftHandedArm_1765750314.stlSTL · 1.3 MB
  • RightHandedArm_1765750315.stlSTL · 1.5 MB
  • Band_Wheel_1765750316.stlSTL · 1.3 MB

Make a variant with AI

Build another version of this model.

Open Studio

Details

Model ID
#97501
Category
Máy In 3D
Published

Description

  • If you have trouble installing the rubber band, look at the pic of the back, that shows a closeup of the rubber band.

A belt tension meter for GT2 6mm and 9mm belts.

This requires one 608 (22x8x7mm) bearing. I used the 6082rs variant, which has a rubber seal on each side.  It also requires one thin walled rubber band, which serves as the spring, threaded through an opening in the backside of the lever arm.

The band wheel will be a tight fit, but presses into its corresponding hole in the meter body.  If you want to insure that it never comes out, a drop of superglue will do nicely.

The index markings aren't meant to correspond to any specific belt frequency or tightness value. It's for comparative purposes.  Set your belt to a specific level of tightness using an audio spectrometer app, then put this meter on that belt  and record the meters number reading.  

With the rubber band I used,  a level of tightness that gives me 145hz using the Android “Spectroid” app, corresponds to #2 on the meter.   Using the meter, I was pretty quickly able to adjust my other belts to this same setting.

My recommendation is that you set one belt to a specific level of tightness using an audio spectrometer app.  Once you have that done, put this meter on that belt to determine which setting you will adjust all of your other belts to match.   After you have this setting, it will be easy to adjust all of your belts in the future, using this meter.

Read more Show less

Print spec

Formats
stl
Model files
5
Total size
11 MB
Largest file
3.5 MB

0 comments

See all