Skip to main content
F3D
Giá đỡ pin Anker Nano cho Pico 4/Pro 1

4 images

Dụng Cụ Tiện Ích

Giá đỡ pin Anker Nano cho Pico 4/Pro

By cucumberworks_180399

Downloads
57
Likes
9
Views
767
Comments
1

Files 4 4.3 MB

  • Main_1765459720.stlSTL · 2.8 MB
  • p4pBatConnector_1765459805.stepSTEP · 320.4 KB
  • Cap_1765459826.stlSTL · 367.4 KB
  • p4pBatConnector_1765459843.stlSTL · 912.5 KB

Make a variant with AI

Build another version of this model.

Open Studio

Details

Model ID
#75936
Published
Tags

Description

This is a battery mount that uses the Anker Nano Power Bank(10,000mAh) with a built-in USB-C cable.

Recommended print settings:

Placed on build plate on sides

≥3 wall loops

Tree support

My print was done on a Bambulabs A1 Mini with PLA-CF. PLA-CF is a strong and rigid material for this application.

Extra stuff you need:

2 M3*16 screws

2 M3 nuts(lock nuts preferred)

4mm(D)*5mm(H) magnets(from 4 to 12, 12 is overkill, 8 is enough)

The magnets are for the quick release cap

The mount uses 3M VHB tape to attach to the headset. You need 6 patches as shown in the picture provided. Tested on the Pico 4 Pro. Not guaranteed to work on the standard Pico 4 as I don't have a unit to test with.

The p4pBatConnector is an accessory that can be attached to the side band of the Pico 4 with VHB and zip ties to allow for a magnetic charge connector. The type of USB-C magnetic adapter is very specific. If you cannot find the model. It is recommended to just use a short USB-C extension cable(about 20cm) to connect the battery to the headset. Or modify the step file provided.

Read more Show less

Print spec

Formats
stepstl
Model files
4
Total size
4.3 MB
Largest file
2.8 MB

1 comment

See all