Skip to main content
F3D
Gravity Broom Holder - Fully Captive Gear, Extended Range 1

6 images

Đồ Gia Dụng

Gravity Broom Holder - Fully Captive Gear, Extended Range

By JoeMalovich

Downloads
1,104
Likes
206
Views
3,501
Remixes
1
Comments
39

Files 3 1.4 MB

  • BroomHolder_Extended_Captive_1765620979.stlSTL · 461.5 KB
  • BroomHolder_Extended_Captive_1765620980.stepSTEP · 658.6 KB
  • BroomHolder_Solid_Gear_1765620981.stlSTL · 265 KB

Make a variant with AI

Build another version of this model.

Open Studio

Remix versions 1

See all 1 remix

Details

Model ID
#71263
Category
Đồ Gia Dụng
Published

Description

Can grab from about 20mm to 37mm diameter, 10mm more range than the original model.

Uses the same stock gear.

The gear gets clipped in place before the Broom Holder is mounted on a wall. Once mounted the gear is completely captive.

No supports required, 0.6mm outer line width and 0.2mm layer height recommended for the overhang to come out nice.

Use thicker extrusion settings for a sufficiently strong model, I caution against using PLA due to creep.

Reference the original model page for more information.

May/7/23 Rev Notes: Tightened up gear captive features, made screw holes slightly larger.

June/25/23 Rev Notes: Added clearance for rubber band on the gear and correct model orientation.

Nov/23/23 Rev Notes: Added some missing chamfers.

Read more Show less

Print spec

Formats
stepstl
Model files
3
Total size
1.4 MB
Largest file
658.6 KB

39 comments

See all