Skip to main content
F3D
Giá đỡ cuộn filament MK3 kiểu thấp cho máy in 3D 1

3 images

Máy In 3D

Giá đỡ cuộn filament MK3 kiểu thấp cho máy in 3D

Remix of Giá đỡ cuộn filament trơn tru nhất cho máy in 3D By Gabe_1702

By MrNeedlemouse

Downloads
290
Likes
77
Views
2,939
Comments
9

Files 4 255.5 KB

  • main-holder-low_1766303977.stlSTL · 30.6 KB
  • spool_center_1766303978.stlSTL · 97.6 KB
  • spool-arm_1766303979.stlSTL · 115.1 KB
  • clip-test_1766303980.stlSTL · 12.2 KB

Make a variant with AI

Build another version of this model.

Open Studio

Description

This will not fit the MK4 (yet).

As space is limited in my cabinet I created a low-profile version of the "Smoothest Rolling Spool Holder". A filament-guide is highly recommended to avoid the filament tugging against the upper frame.

2x 8*22*7mm bearings needed.

For MK3s in 60x60 IKEA Platsa cabinet. Enjoy!

Print instructions

I printed the main arm in 0.2 layer height with 23% infill and 3 perimeters, PLA. But PETG is probably preferred. Print the holder in same layer height or thinner. The press-fit slot may need some light sanding, the fit is tight.

To make the roller become the "smoothest rolling", scale the roller (spool_center) to 99% since I would say the fit for the spool roller is too tight on the bearings and holder at 100%. I printed it on a raft on its side with support at 0.2mm layer height using Prusament PETG Orange.

Read more Show less

Print spec

Formats
stl
Model files
4
Total size
255.5 KB
Largest file
115.1 KB

9 comments

See all