Skip to main content
F3D
Giá Treo Dụng Cụ Ryobi 18v Lên Bảng Pegboard 1

7 images

DIY

Giá Treo Dụng Cụ Ryobi 18v Lên Bảng Pegboard

Remix of Bộ giữ dụng cụ Ryobi cho Pegboard (Đã cập nhật) By theamzngq

By TBKHomeworld_1307458

Downloads
369
Likes
35
Views
1,854
Comments
1

Files 14 10.5 MB

  • Ryobi-PegBoard-Combined_1765844248.stlSTL · 4.1 MB
  • Ryobi-PegBoard-Pitched_1765844249.stlSTL · 462.3 KB
  • Ryobi-PegBoard-Flat_1765844251.stlSTL · 398.5 KB
  • Ryobi-PegBoard-Rail-Long_1765844252.stlSTL · 1.6 MB

Make a variant with AI

Build another version of this model.

Open Studio

Description

2023-11-20 - I have added a 15mm offset for the Ryobi 18v One+ PSP02 Handheld Electrostatic Sprayer.  This allows it to sit very well against the pegboard.  This same model also works for the Ryboi Airstrike 18v One+ P320 Brad Nailer which allows the tool to hang out away from the wall, so far it is holding up great with ASA filament.

2023-10-16 - Updated files with better angled/pitched version as the original had an incorrect bevel.  I have also included a single long rail that takes up a smaller span, allowing for more tool mounts within a given area.  Finally I have also included a 17mm taller version to allow for the dust output from the Ryobi P440 One+ ¼ sheet palm sander.

For the ASA I would advise you use the high temp plate, glue stick, and print a single item at a time.  

Bambu Lab specifics for the prints: 

  • Rails:
    • Walls: 3 wall loops
    • Top/Bottom Shell: monotonic top/bottom with rect infill
    • Sparse Infill: 18% gyroid infill
  • Main Body: 
    • Walls: 2 wall loops
    • Top/Bottom Shell: monotonic top/bottom with rect infill 
    • Sparse Infill: 18% gyroid infill

Original Post:

This is my first attempt at sharing a model, please be kind.  

@theamzngq ‘s model was great but I wanted to be able to rotate the flat base.  I have a lot of Ryobi tools and I will randomly buy new stuff as I need it, being able to rotate the flat base means I am no longer stuck with printing a new one depending on how I want it rotated.  I simply slide the old base off the rails and rotate it at-will.

The angled one is after reading the suggestions from the feedback on his model and I really like how it presents the common shaped tools better (drill, drivers, impacts, etc).

I printed most of these using Bambu PLA though but I also have a few with Bambu ASA too.  For ASA I would leave the brim on to ensure it prints appropriately and does not warp during the cool down.  I used the textured PEI plate with no issues for the tough and I used glue on the hot-plate for the ASA.

Enjoy!

Read more Show less

Print spec

Formats
3mfstl
Model files
14
Total size
10.5 MB
Largest file
4.1 MB

1 comment

See all