Hộp đựng Radius Gauge

This is a case my printable Radius Gauges. See the links to them below. 

Note: One person posted a make of the case claiming that the lid would not fit. The lid is designed to go on one way. If the lid does not fit on the base simply take it off and turn it around. It should fit well and also prevent all of the gauges from spilling out.

Some also complain that the case doesn't latch. I designed it to sit on my desk with the lid keeping the gauges dust free. At some point I may redesign it with a latch. In the meantime you are welcome to remix a latching case or you can just put a rubber band around it if you need to transport it.

Radius Gauge Sets, 0.5 to 7.0mm and 7.5 to 13mm...

https://www.printables.com/model/15817-radius-gauge
https://www.prusaprinters.org/prints/15818-radius-gauge

A360 downloadable file...
https://a360.co/2K9cWE2

Print instructions

Category: 3D Printer Accessories