Bambu Poop Chute - Nam châm 10x3mm

This is a remix of the Bambu Poop Chute by Fantasy3DPrintsShop, modified to suit my needs

This uses 10x3mm magnets to attach to the metal plate on the back of the BambuLabs X1C, P1P and P1S.
The support under the end where the magnets go has been removed as well for a cleaner look.

No supports are required when printing this and I used the below settings when printing it:

• Nozzle: 0.4mm
• Supports: None
• Layer Height: 0.2
• Infil %: 15%
• Brim: None

It used roughly 387g of filament and it took about 12 hours to print on my P1S.

Used a drop of super glue to hold in the magnets.

There is also a great Bambu Poop Chute - Magnet Remix design by Ascii which uses 6x3mm magnets, but I had 10x3mm magnets on hand.