
YAFS - Kệ Đựng Filament Dễ Làm
- Downloads
- 30
- Likes
- 5
- Views
- 294
- Remixes
- 0
- Comments
- 0
Files 4 459.3 KB
- bracket--l_1766324869.stlSTL · 128.3 KB
- bracket-r_1766324870.stlSTL · 128.3 KB
- bracket-nohole-l_1766324871.stlSTL · 101.4 KB
- bracket-nohole-r_1766324871.stlSTL · 101.4 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #64559
- Category
- Máy In 3D
- Published
- License
- Creative Commons — Attribution
Description
I've been searching for a simple bracket/mount to replace my rather old filament shelf. While I liked quite a few of the designs available, I decided to do my own thing.
The hole in the brackets fits 22 mm wooden rods. To make it easier I also added the brackets without the hole so you simply create one that will fit your rod diameter. You can do this directly in any modern Slicer by adding a cylindrical negativemodifier in the right spot.
I've used 2 wooden rods with a length of 240 cm (approx. 95 inch). The recommended spacing of brackets would be 80 - 100 cm for a diameter of 22 mm. On the bottom there are holes for short screws to fix the rods in place. Predrill the screw holes and please handtighten the screws - otherwise you will split the layers! Adding these screws will give the whole shelf more sturdiness.
Recommended print settings:
- 4-5 walls
- 0.2 layer height
- 0.42 extrusion width
- 25% cubic or gyroid infill
- 3 bottom layers
- 4 top layers
Use whatever material you like the most. I used PLA (Prusament Galaxy Black).
Print time @250 mm/s for 1 bracket is approx. 90 minutes.
You can use the bracket either hanging or standing.
Print spec
- Formats
- stl
- Model files
- 4
- Total size
- 459.3 KB
- Largest file
- 128.3 KB
0 comments
You may also like 12 models
See all-

-

-
New -
New -

-

-

-

-

-

-

-


