Skip to main content
F3D
Giá đỡ gắn tường Cisco CBW145AC-E cho điểm truy cập 1

5 images

Dụng Cụ Tiện Ích

Giá đỡ gắn tường Cisco CBW145AC-E cho điểm truy cập

By StickyRib

Downloads
37
Likes
8
Views
347

Files 1 2.5 MB

  • cisco-spacer_1766244287.stlSTL · 2.5 MB

Make a variant with AI

Build another version of this model.

Open Studio

Description

The Cisco CBW145AC access point is fed from an ethernet port on the back. This is easy enough if the ethernet cable passes out of the wall. Where this isn't possible, this bracket allows the AP to be mounted to the wall and for the cable to pass up from underneath.

This approach requires an ethernet cable with a 90 degree plug like this one. The space within the bracket to allow for the cable is 25mm.

The hole for the cable to pass through is quite tight for the plug, but it is easy enough to pass the plug through with a bit of turning.

The mounting plate that comes with the AP is attached to the 3D printed bracket with 3mm x 6mm bolts. The threads in the printed part are designed to size - I ran a 3mm X 0.5mm tap through the threads to clean them up prior to assembly.

There are two mounting holes to attach the bracket to the wall, but only one needs to be used if you're not worried about the AP moving slightly.
With the mounting screw not over tightened, the mount can be slid up and removed easily without removing the screw.

Read more Show less

Print spec

Formats
stl
Model files
1
Total size
2.5 MB
Largest file
2.5 MB

0 comments

See all