
Nắp che kết nối đĩa nóng cho Flash Forge Adventurer 4
- Downloads
- 21
- Likes
- 6
- Views
- 273
- Remixes
- 0
- Comments
- 0
Files 2 624 KB
- Adventurer_4_Hotplate_Connector_Cover_1766155880.STEPSTEP · 332.4 KB
- Adventurer_4_Hotplate_Connector_Cover_1766155880.STLSTL · 291.6 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #52992
- Category
- Máy In 3D
- Published
Description
The hot plate connector cover on my Adventurer 4 got deformed from the heat and no longer worked right. The cover's clip also broke because it was melted into place.
The original part was made from ABS. I recommend printing it in ASA since that holds it shape better at 100c.
This was reverse engineered from the original part that was deformed, but it will fit perfectly into place. Modeled in SolidWorks.
I left off the ribs on the top of the cover so that it could lie flat on the printer surface without supports. I used supports for my test print so the clip would not fail, other orientations did not fair much better. I found flat on the printer works best.
I did extend the clip part a bit more to grab the edge better.
The crease in the cable should be under the cover. It is left out in my picture to make taking the picture easier.
Print spec
- Formats
- stepstl
- Model files
- 2
- Total size
- 624 KB
- Largest file
- 332.4 KB
0 comments
You may also like 12 models
See all-

-

-

-
New -
New -

-

-

-

-

-

-


