
ExoGuitar - Shoulders - Double Cut (Vai đàn dạng cắt kép)
- Downloads
- 2
- Likes
- 0
- Views
- 36
- Remixes
- 0
- Comments
- 0
Files 5 7.7 MB
- exoguitar_shoulders_double-cut_model--shoulder-v3-doublecut_1785764093.stepSTEP · 386.9 KB
- exoguitar_shoulders_double-cut_model--shoulder-v3-mini_1785764094.stepSTEP · 386.9 KB
- exoguitar_shoulders_double-cut_model--shoulder-v3_1785764094.stepSTEP · 386.9 KB
- exoguitar_shoulders_double-cut_print--shoulder-v3-mini_1785764095.3mf3MF · 3.3 MB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #417195
- Category
- DIY
- Published
Description
Part of the ExoGuitar project — full catalog, build planner, and assembly guides at https://exoguitar.com
Plan Your Build & Get Hardware
ExoGuitar can be confusing! Head over to our build planner to plan your entire build - it'll walk you through every available part and handle compatibility along the way, and it covers all ExoGuitar parts. It's also the best way to get hardware, since it lets you buy everything for a full build in one go, not just this part.
You can find this specific part, ExoGuitar - Shoulders - Double Cut, on our site.
Step 1: Insert Carbon Fiber Rods (Optional)
For extra stiffness, cut a 3x6 Carbon Fiber bar until you have 2x 90mm lengths of it.
Locate the rectangular holes on the bottom of the shoulder that don't have balled corners.
Make sure that any support material in those holes has been removed. It's a tight fit.
Put some CA glue in those holes.
Using a small hammer, tap in the 3x6 Carbon Fiber Bars until they are fully seated in the shoulder.
Step 2: Tap 2020
Tap the end of the 2020 with a M6 Tap
Repeat for the other 2020
Step 3: Drill Side Holes
Using a M6x20 BHCS, secure the smaller drill jig to the top of the 2020
Using a M5 drill bit, drill a hole straight through the 2020 using the drill jig as a guide
Swap to the larger hole'd drill bit
Using a M10 Drill bit, drill just the outer edge of the rail away so the screw can nestle inside of the 2020 rail.
Remove the drill Jig
Repeat for the other 2020
Step 4: Mount Shoulder to 2020
Using 2x M6x20 screws, mount the Shoulder to the top of the 2020's.
Put two M5 Nuts in the square holes in the face of the shoulder
Finally, put two M5x35 screws through the 2020's into the shoulder until they thread into the nuts from the last step.
Step 5: Mount Neck
Using 5x M5x35 SHCS and 5x M5 Slide In Nuts, attach the neck to the shoulder.
Hardware
DIY Kit
You can order a DIY kit for your entire build from our build planner, the estimate for this part's kit is $15.55 plus shipping.
Self Source
If you want to order the parts yourself, here's a list. Estimated cost: $48.95.
Print spec
- Formats
- 3mfstep
- Model files
- 5
- Total size
- 7.7 MB
- Largest file
- 3.3 MB
0 comments
You may also like 12 models
See all-

-

-

-
New -
New -

-

-

-

-
New -
New -
New

