Skip to main content
F3D
Mô hình Mini SVS PB-17 Ultra Subwoofer (Tỷ lệ 1:6) 1

6 images

Dụng Cụ Tiện Ích

Mô hình Mini SVS PB-17 Ultra Subwoofer (Tỷ lệ 1:6)

By Turbosol_2577940

Downloads
86
Likes
53
Views
941

Files 8 12.4 MB

  • SVS_PB-17_Ultra_for_2.5in_Sub_All_parts_in_one_file_1785740547.3mf3MF · 2.1 MB
  • SVS_logo_badge_for_grill_.2_nozzle_.08_layer_height_AMS_1785740549.3mf3MF · 72.7 KB
  • SVS_TPU_port_plugs_optional_for_better_sound_quality_1785740550.3mf3MF · 56.7 KB
  • SVS_PB-17_TPU_Feet_1785740551.3mf3MF · 62.6 KB

Make a variant with AI

Build another version of this model.

Open Studio

Details

Model ID
#417068
Published

Description

This is a 1:6 scale replica of the legendary SVS PB-17 Ultra home theater subwoofer. It designed mostly just as a toy but I was surprised how good it actually sounds! Definitely a decent bluetooth speaker.

PARTS LIST:

Speaker: Dayton Audio ND65-8 2-1/2"

 Amplifier: ZK-MT21 2.1 Channel Bluetooth Amplifier Board – Mini

 Screws for speaker box assembly: 

Either M3x4 self tapping screws or M2.5x4 should work fine (for speaker, TPU feet, and rear box plate) 

 Magnets: 4x2mm (12 of them), you only need these if printing the speaker grill cover  

 ASSEMBLY:

 1. Wire up and screw in the speaker from the inside 

 2. The port tubes need to be inserted and glued together, they come in 3 pieces, the front port sections, the elbows and the vertical port sections. These press fit ok but you probably want to glue them too. After the ports are installed you will need to place the support bar inside the box and put a dab of glue between it and the port pipes so they stay in place (pictured above). I also have optional tpu port plugs (2) that you can insert into the vertical ports inside the box to block them off, I found that the bass and sound quality is much better with 2 ports plugged with such a small speaker. 

 3. pull wires through back panel

 4. install box back with 4 screws

 5. install tpu feet on bottom of box (either with glue or with screws)

 Lasty the speaker grill is optional, but if you want to use one then you print it out, cover it with speaker grill fabric (using 3m spray glue), then you glue in 4x2mm magnets into both the box and speaker grill. I also included a file for the mini SVS logo for the speaker grill. 

PRINT SETTINGS:

Any hard filament for box and ports, I used carbon fiber PETG for a great satin finish that hides layer lines

Feet and port plugs obviously get printed in TPU

 .2 nozzle is needed for the optional SVS logo for the speaker grill because the details are so small.

If you would like to leave a tip for my hard work you can do so here :D https://www.paypal.com/ncp/payment/Y5DRF7PN8S5AJ

Read more Show less

Print spec

Formats
3mfstl
Model files
8
Total size
12.4 MB
Largest file
9 MB

0 comments

See all