Đế đỡ Polymaker PolyDryer phiên bản cao hơn có kèm chân TPU

This is simply a taller version of Watchful Eye's fantastic stand for the Polymaker PolyDryer, scaled up to match the height of the dryer (when the TPU feet are installed).

I use my PolyDryers with Vorons and similar printers that have electronics that need cooling behind side skirts blocked by the PolyDryer box. This raises it up to enable air flow beneath the box (when the dryer is not in use of course). And your Bowden feed tube can now be the same length regardless of whether the box is on-or-off the dryer too.  

I did not need to remix the TPU feet which you can download from the original model: 

Without the feet, the stand is just a few mm shorter and is barely noticeable if you size your Bowden tube accordingly. I have found that the TPU feet are really a nice-to-have rather than a necessity as the weight of the box and filament prevents things from sliding around, even on the slippery Formica laminate on some of my workbenches. You can also order rubber stick-on-feet from Amazon and-the-like if you do not want to deal with TPU. 

I printed these in Polymaker ASA on Voron and RatRig printers using the standard Voron print settings: 

• Layer height: 0.2mm

• Extrusion width: 0.4mm, forced

• Infill percentage: 40%. --> recommended for functional parts that are subject to regular use.

• Infill type: gyroid or cubic --> cubic is much faster and the same strength as gyroid.

• Wall count: 4

• Solid top/bottom layers: 5

• Supports: NONE

• Brim: if needed for your filament

Hope you like it and happy printing!