
Ngàm giữ lưới lọc bụi 200mm cho quạt case PC
Remix of Giá đỡ bộ lọc bụi lưới cho quạt case PC 120mm By Josh0_889508
- Downloads
- 2
- Likes
- 0
- Views
- 24
- Remixes
- 0
- Comments
- 0
Files 8 22.7 MB
- 200mm_PC_fan_mesh_filter_holder_v1.0-0.2mm_Base_1784619445.stlSTL · 5.8 MB
- 200mm_PC_fan_mesh_filter_holder_v1.0-0.2mm_Cover_1784619446.stlSTL · 233.3 KB
- 200mm_PC_fan_mesh_filter_holder_v1.0-0.4mm_Base_1784619447.stlSTL · 5.8 MB
- 200mm_PC_fan_mesh_filter_holder_v1.0-0.4mm_Cover_1784619449.stlSTL · 233.3 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #414587
- Category
- Dụng Cụ Tiện Ích
- Published
- License
- Creative Commons — Attribution
Description
Some mesh dust filters for PC case fans have a magnetic backing meant to attach to a steel PC case. They work well with steel but some case locations are fully plastic so magnetic items won't work (unless affixed using tape/glue or screws). I wanted to easily remove the filters for cleaning so I designed this holder. Once assembled you can slide the mesh filter in and out of one end, no disassembly required.
The holder is designed to work with this mesh filter:
DEMCiflex 200mm Square Computer Dust Filter
The holder should fit 200mm fans and cases with holes spaced 170mm apart or holes spaced 154mm apart. Example PC case fan:
Noctua NF-A20 PWM
Design notes:
Both pieces, base and cover, should be printable without supports if your printer can tolerate 45º of overhang. The two pieces snap together. If necessary the pieces can be separated by hand but if you don't have sufficient finger access then insert a small flat-head screwdriver into the rectangular holes (one at a time) in the front of the cover to gently pry the sides loose. The honeycomb pattern gives the base some structural rigidity and prevents the filter mesh from being sucked into the fan. The two tabs on the bottom of the cover help align the cover to the base, they are not part of the latching mechanism. The round holes in the base are designed to accommodate #8-32 machine screws and to completely envelop the heads of the screws (typically about 2.6mm high). Longer screw heads might rub against the filter frame when sliding the filter in or out. Other types of screws might work as well.
Since I own neither a 200mm fan nor a 200mm mesh filter I cannot verify the fit, the models were designed using specifications found on the websites of the filter and fan. This design was made from a user request.
Print notes:
I have provided files for two different clearances (between the printed pieces and the filter): 0.2mm and 0.4mm. If you find that the 0.2mm clearance print is too snug then try the 0.4mm clearance models. I typically print parts using 20% infill density and a wall thickness of 0.8mm (for both parts), other settings might work as well.
Print spec
- Formats
- stepstl
- Model files
- 8
- Total size
- 22.7 MB
- Largest file
- 5.8 MB
0 comments
You may also like 12 models
See all-
New -

-

-

-

-

-

-

-

-
New -

-

