
Cữ Dán Phôi Bút Ghép (Segmented Pen Blank Angle Glue Up Jig)
- Downloads
- 0
- Likes
- 2
- Views
- 49
- Remixes
- 0
- Comments
- 0
Files 3 9.8 MB
- BFL_SegmenttedAngleGlueBlock_1784369745.3mf3MF · 1.6 MB
- BFL_SegmentedGlueUpVise_1784369746.stlSTL · 4.1 MB
- BFL_SegmentedGlueUpBody_1784369748.stlSTL · 4.1 MB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #414096
- Category
- DIY
- Published
Description
There's really nothing special about this model...except that it has a very special use. If you are doing a segmented pen turning and want to do a herringbone pattern on your blank, this jig is extremely useful to clamp sections while you do a CA glue up.
I recommend you either use frequent applications of mold release spray or something else to keep the work from sticking to the jig (although this will be inevitable). I find that my mix of vaseline and naptha that is being used for a silicone mold release agent works well here but you have to make sure your mating surfaces stay clean.
To print: Both parts are recommended to be printed with PETG using 25% gyroid infill, 5 wall loops for strength. You will likely need to print on two plates due to the size.
To use: Slot the moveable side into the dovetails and use a long squeeze clamp to apply pressure.
Helpful hints: I use a small kabob stick once I apply light pressure to push in each one of these slabs until tight. I also use thin CA glue so that it flows into all of the tiny voids when mating surfaces together.
That's about it! Enjoy.
Print spec
- Formats
- 3mfstl
- Model files
- 3
- Total size
- 9.8 MB
- Largest file
- 4.1 MB
0 comments
You may also like 12 models
See all-
New -

-

-

-
New -
New -
New -

-

-
New -

-
New

