Skip to main content
F3D
Bộ chuyển đổi pin AA cho máy xúc ProfessorBoots 1

7 images

DIY

Bộ chuyển đổi pin AA cho máy xúc ProfessorBoots

Remix of Tự làm máy xúc điều khiển từ xa RC bằng máy in 3D By ProfJohnny_823077

By AJoy_4179427

Downloads
4
Likes
1
Views
75

Files 5 350 KB

  • Rear_Cover_Modified_for_AA_Rev_2_1784358808.3mf3MF · 129.4 KB
  • AA_Battery_Tray_and_Top_Cover_for_PB_Excavator_1784358808.3mf3MF · 65.9 KB
  • AA_Battery_Tray_for_PB_Excavator_1784358809.stlSTL · 14.9 KB
  • Rear_Cover_Modified_for_AA_Rev_2_1784358810.stlSTL · 76.4 KB

Make a variant with AI

Build another version of this model.

Open Studio

Description

After getting tired of waiting for the Fenix batteries to ship, I decided to create a conversion to run the excavator with AA batteries.

Starting with four AAs, it was lacking the power to really do anything, so I increased it to six. This provides a bit extra voltage compared to the original model at approximately 9V. There is now plenty of power. Additionally, I am going to try out the PaleBlueEarth USBC rechargeable AAs which should have at least 1000 mAh more capacity than the Fenix CR123As. I will update with results. As for now, the Alkaline AAs work great too.

The 3D prints are relatively straight forward, a small amount of supports are necessary.

Once printed, attach the battery contacts (something similar to the one linked below) to the tray, these should all be wired in series and then to the PCB (All other wiring is the same as the original). The tray then just gets pressed into the modified rear cover with a small chamfer that helps hold it in place. 

The top cover then snaps into the same groves that are there to allow the contacts and wires to pass through.

Note: I did not include polarity symbols on the tray or cover, simply because it can be wired a few different ways to get the correct voltage. It will be up to the user to figure that out and add them in the slicer if needed.

https://paleblueearth.com/collections/voyager-usb-c-rechargeable-batteries/products/voyager-aa-rechargeable-batteries

https://www.amazon.com/dp/B0GTVNBSB5?ref=ppx_yo2ov_dt_b_fed_asin_title

Read more Show less

Print spec

Formats
3mfstl
Model files
5
Total size
350 KB
Largest file
129.4 KB

0 comments

See all