Skip to main content
F3D
Bộ chuyển đổi băng đạn Talon cho Nerf N Series Infinite 1

7 images

Thể Thao & Ngoài Trời

Bộ chuyển đổi băng đạn Talon cho Nerf N Series Infinite

By J4N_78795

Downloads
1
Likes
1
Views
53

Files 4 481 KB

  • infinite_barrel_spacers_1784337227.stlSTL · 50.1 KB
  • infinite_test_1_1784337228.stlSTL · 276.8 KB
  • infinite_pusher_cap_1784337229.stlSTL · 79 KB
  • extended_barrel_cover_1784337230.stlSTL · 75.1 KB

Make a variant with AI

Build another version of this model.

Open Studio

Description

Used in conjunction with the barrel installation pieces from Hawki007's kit. https://ade-line.com/products/infinite-short-dart-conversion-kit

The mag adapter requires two 6x7mm ball bearing detents. Print the barrel spacer twice, so that the priming mechanism doesn't get caught on the barrel installation pieces before the plunger catches. Apply plastic-safe lubricant.

YOU WILL NEED TO REMOVE THE SAFETY VALVE WITHIN THE PUSHER. Snip the four support pegs at the back of the pusher, so that the spring and pieces fall out.

Included is an experimental tip for the pusher. It allows better dart feeding, but it also restricts the air going into the barrel. If air leaks out the rest of the system faster, then you'll need to cover the air bleed holes in the plunger tube and will likely need to swap out the stock spring for a stronger one to compensate. Try it if you want, but only use light amounts of adhesive in case you need to pry the tip back off.

I've also included an extended barrel cover. Hawki's adapter fits barrel material tightly, so if you use shorter barrels in your Infinite, that should be sufficient...but a dab of adhesive would be recommended.

Leaving this as a WIP as testing continues. But so far it feeds and fires!

Category: Sport & Outdoors

Read more Show less

Print spec

Formats
stl
Model files
4
Total size
481 KB
Largest file
276.8 KB

0 comments

See all