
Các linh kiện nâng cấp cho TM G17 Gen 4
- Downloads
- 1,309
- Likes
- 161
- Views
- 19,446
- Remixes
- 0
- Comments
- 0
Files 7 4.4 MB
- Glock_Fiber_Sights_Front_Post_1784322301.stlSTL · 62.4 KB
- G17-Barrel-Threaded_1784322303.stlSTL · 512.3 KB
- compensator_type_2V2_1784322304.stlSTL · 1.7 MB
- Glock_Fiber_Sights_Rear_Post_1784322304.stlSTL · 161.6 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #412654
- Category
- Thể Thao & Ngoài Trời
- Published
Description
The Tokyo Marui G17 gen 4 is a little different than the 3 and required some work to get the parts to work.
Here I present to you my modified gen 4 parts:
A barrel originally designed by OpenAirsoft, with a little sanding and racking of the slide I got it to run smoothly. I recommend heating the little connecting piece on the side that the tab from the hopup assembly fits in so that you can slide the inner barrel in and then push it back down flat, otherwise it will snap when installing.
Fiber optic sights by Xdr4g0nX, I modified them to work with .078" TruGlo replacement fibers.
Compensators by Foxstrat, I modified them to sight almost flush with the slide when using the barrel above.
A magplate that I found outside of Thingiverse but was too long for my taste so I shortened it a little.
A back plate that doubles as a flared charging handle.
Print Settings
Printer Brand:
Prusa
Printer:
I3 MK3S
Rafts:
Doesn't Matter
Supports:
Yes
Resolution:
.2
Infill:
30%
Filament: Polymaker ASA Red
Print spec
- Formats
- stl
- Model files
- 7
- Total size
- 4.4 MB
- Largest file
- 1.7 MB











